Fuser-motor assembly (M299)
1 . Remove the following components:
• Top accessory cover.
• Formatter cover and cage.
• Top cover.
• Right-side cover.
• DC controller.
2. Release one spring (callout 1 ).
A CAUTION: The spring is not captive. Do not lose the spring. _
Figure Remove the fuser-motor assembly
3. Remove two screws (callout 2) and then remove the guide (callout 3).
Figure Remove the fuser-motor assembly
4. Disconnect one wire-harness connector (callout 4), and then remove three screws (callout 5). Remove the fuser-motor assembly.
^ NOTE: You must install the fuser-motor wire harness on the replacement fuser-motor assembly.
Figure Remove the fuser-motor assembly
0 komentar:
Posting Komentar